You're on southern hemisphere timings. I grow in the UK, so when the text below mentions a month, add six months to it. January sowing becomes July.
The moment your seedlings break the surface, they start looking for light. In a UK January or February there isn’t much of it, and what there is comes in low and weak. Too little and they stretch into tall, floppy seedlings. Too much and the leaves bleach and drop.
At a glance
- Get seedlings under light as soon as the first seed leaves appear.
- A winter windowsill usually isn’t enough. A cheap daylight bulb or LED makes a big difference.
- Run lights on a timer, about 16 hours on and 8 off.
- Seedlings need less light than you’d think. Start an LED high and dim, and read the leaves.
- Leggy means not enough light. Purple, bleached or curling leaves mean too much.
Light from the moment they sprout
Seeds don’t need light to germinate. But as soon as you see the cotyledons (the first pair of little seed leaves), they need it straight away, or they’ll start stretching. So check your tray daily and have your light ready.
Windowsill or grow light?
If you’re starting in January or February in the UK, a windowsill on its own won’t give you enough light. The days are short and the sun sits low, so seedlings on a January windowsill grow straggly.
Closer to spring, a sunny windowsill can work. Pick a south-facing window if you’re in the northern hemisphere, or north-facing in the southern hemisphere. Seedlings on a windowsill will lean towards the glass, so turn the tray every day or so to keep them growing straight.
You don’t need expensive kit to give them artificial light. Any of these will grow good seedlings:
- A daylight compact fluorescent (CFL) bulb, 5500K or 6500K (around 20 watts), in a clip-on fitting or a desk lamp. This is the cheapest way to start.
- High-output 6500K T5 fluorescent tubes. They’ve been my seedling favourite for years. The light quality is fantastic, and it’s very hard to give too much light with them, so they can sit right on top of the plants.
- A cheap LED strip, herb light or small panel. These are fine for seedlings.
- A quality dimmable LED, if you want one light that will carry plants further.
Watch out Don’t use old incandescent bulbs or “warm white” bulbs. They run hot and waste power, and most of their light is at the yellow and red end. Seedlings want blue for early leafy growth. Look for “daylight” or 6500K on the box.
How many hours a day
I run my lights on a fixed timer at 16 hours on and 8 hours off, and that’s where I’d start.
Tip If your lights are in a cold room, shed or tent, time them to run through the night. That’s when it’s coldest, and the bit of heat the light gives off helps keep the seedlings warm.
How close: start high and dim
Modern LEDs are deceptive. Our eyes are most sensitive to yellow and green light, while plants mostly use red and blue, so a grow light can look dimmer to you than it really is to a plant. Most growers, me included, give seedlings too much light. Chillies do well on surprisingly little.
There’s no single right distance, because every light is different. So this is what I do:
- Set an LED higher and dimmer than you think it needs to be. Around half power, or the lowest setting, is a good start for seedlings.
- Check the leaves every day.
- Change one thing at a time, a little at a time: a bit lower, or a bit brighter. Then wait a few days and have a look again.
If you’d like numbers, a cheap lux meter helps. For young seedlings under a full-spectrum LED, I aim for about 2,000 to 2,500 lux at the leaves, and not much above 4,000 to 5,000 lux early on. That rises to around 6,000 lux at one to three months, or once they start flowering. Fluorescent bulbs and tubes are much harder to overdo, so you can keep those close.
Leggy seedlings and how to fix them
Leggy seedlings are tall and thin, with a long bare stem and big gaps between the leaves. They’re stretching to find light, usually because the light is too far away or too dim.
- Bring the light a little closer or turn it up a little. Don’t overdo it.
- If they’re on a windowsill, add a cheap daylight bulb or LED.
- When you pot them on (move them into a bigger pot), bury the stem deep, right up to the lowest true leaves. Chilli stems grow roots wherever they’re buried, so the plant ends up compact and sturdier. There’s more on this in Step 5, Potting up & soil.
Legginess can be fixed. Too much light is the bigger worry, because it can stunt or even kill young seedlings. If in doubt, err on the side of less.
Signs of too much light
- Leaves darkening to purple or nearly black. It’s like a suntan: the plant is protecting itself. This is the mildest sign, and it recovers easily.
- Leaves curling, flopping or closing up. Curling can also be heat, so check whether a fan helps.
- Burnt leaf tips.
- Smaller new leaves, as the plant tries to catch less light.
- Pale, washed-out (bleached) leaves, which mean far too much light. Those leaves will die and drop off.
If you see any of these, raise the light or dim it. And if the leaves are pointing up towards the light and looking happy, you can try bringing it down slightly. Chillies are resilient. Give them decent light again and the new growth will come through healthy.
In my words I had a tray of seedlings under an older Mars Hydro LED with no dimmer, running full blast. The distance looked decent enough, but the leaves went small, bleached and started falling off. Right next to them, the same-age plants under a cheap little herb-garden light were deep green and absolutely perfect. So get a light you can turn down.
More videos on this
Common questions
Can I leave my grow light on 24 hours a day?
You can. Chillies don’t need darkness to trigger flowering, so 24 hours won’t confuse them. But it costs more in electricity, and it’s easy to give young seedlings too much total light. I stick with about 16 hours on and 8 off.
Do I need a red and blue “blurple” light?
No. For seedlings you want blue-rich daylight (around 6500K), because blue drives early leafy growth. Red matters more for flowering and fruiting, and by then most of us have our plants outside in real sunshine. A white full-spectrum LED or daylight fluorescent is ideal.
Saved on this device only, so you can see where you got to next time.
